Cup handles, help please.

From Sketchup to pencil and paper, discuss your design and development ideas here.
Bighat
Occasional Poster
Posts: 83
Joined: Wed Aug 27, 2014 6:40 pm
Contact:

Cup handles, help please.

Postby Bighat » Sun May 31, 2015 8:35 am

Hi guys, I'm trying to draw some cup handles on drawers on sketch up, but I cannot do it. I drawer the curve of the drawer pulls in plan and profile, but I can't get the solid face of the pull itself to form. What I get is essentially a L bracket with two curves to it, but not the face (the bit you would put your fingers in to pull). Does this make sense? Any help welcomed. Cheers, Bighat

User avatar
nickw
Subscriber
Posts: 2021
Joined: Wed Oct 10, 2007 12:09 pm
Location: Cambridge
Contact:

Re: Cup handles, help please.

Postby nickw » Sun May 31, 2015 7:18 pm

I think DaveL did a video on that on the Fine Woodworking website but it was a while ago
Nick Webb, Fine Furniture, Cambridge
Those who would give up Essential Liberty to purchase a little Temporary Safety, deserve neither Liberty nor Safety.
Banjamin Franklin

Bighat
Occasional Poster
Posts: 83
Joined: Wed Aug 27, 2014 6:40 pm
Contact:

Re: Cup handles, help please.

Postby Bighat » Mon Jun 01, 2015 7:24 am

I will have a look to see if I can find it, thanks. It's driving me mad!

User avatar
nickw
Subscriber
Posts: 2021
Joined: Wed Oct 10, 2007 12:09 pm
Location: Cambridge
Contact:

Re: Cup handles, help please.

Postby nickw » Wed Jun 03, 2015 3:57 pm

Sorry, that should've been DaveR
Nick Webb, Fine Furniture, Cambridge
Those who would give up Essential Liberty to purchase a little Temporary Safety, deserve neither Liberty nor Safety.
Banjamin Franklin


Return to “Design/Development”

Who is online

Users browsing this forum: No registered users and 2 guests