Timber strengthening

From Sketchup to pencil and paper, discuss your design and development ideas here.
MrAtkinson
New Member
Posts: 1
Joined: Fri Jan 15, 2016 9:54 am
Contact:

Timber strengthening

Postby MrAtkinson » Fri Jan 15, 2016 9:58 am

Hi guys,

I am creating a project where i will be routing out a solid piece of oak, walnut and ash. I will be using 20mm thick pieced and have a large area (450mm x 470mm) routed down to 7mm thickness to allow a drawer to be fitted. Obviously this is quiet thin so i was wondering if there is anyway of strengthening it withit getting much bigger than 7mm?

Any suggestions would be much appreciated.

Cheers

tusses
Subscriber
Posts: 3484
Joined: Sat May 24, 2008 11:06 pm
Contact:

Re: Timber strengthening

Postby tusses » Fri Jan 15, 2016 1:50 pm

frame and panel might do, but without more details on your design, can't say for sure


Return to “Design/Development”

Who is online

Users browsing this forum: No registered users and 1 guest