Scm sintex setup

General wood working tips, tricks and ideas. Anything that doesn't belong elsewhere can be discussed here.
Post Reply
murdoch
New Member
Posts: 43
Joined: Sat Aug 30, 2014 10:58 am
Location: Suffolk
Contact:

Scm sintex setup

Post by murdoch » Thu Jan 05, 2017 12:45 pm

I know quite a few people on here this machine and wondered if anyone can tell me how to raise or lower the first bottom head so it planes perfectly flush with the bottom outfeed table?
http://Www.murdochjoinery.co.uk" onclick="window.open(this.href);return false;

senior
Subscriber
Posts: 3305
Joined: Sat Oct 25, 2008 3:13 pm
Location: on the sofa
Contact:

Re: Scm sintex setup

Post by senior » Thu Jan 05, 2017 2:35 pm

remove the ventilated gaurd below it, loosen off the allen screw attached to a rod.
Make sure the bed is raised to full height about 110mm, in line and behind the first outfeed knurled feed wheel is a plate with 3 grub screws, the back one is turned to raise or lower the spindle.
Never done it as mine has been spot on from day one but I have the manual.


THIS IS FOR THE ORANGE AND WHITE MACHINES, post 2003.
Have a look at my facebook page and leave a comment or two.
Or browse my website Hand made kitchens Essex

murdoch
New Member
Posts: 43
Joined: Sat Aug 30, 2014 10:58 am
Location: Suffolk
Contact:

Re: Scm sintex setup

Post by murdoch » Thu Jan 05, 2017 3:46 pm

Thanks so much for that, just adjusted and it's now perfect. Help much appreciated
http://Www.murdochjoinery.co.uk" onclick="window.open(this.href);return false;

Post Reply