Bit of a noob question but here's the thing..
I bough a Record Power TS200C 10" table saw the other year and have just ordered a replacement blade. (A Freud LP30M - 250 x 2.8 x 30 x 40T )
But on installing the blade it slips. It would appear that it is thinner in the body around the bore than the previous blade by a hair.
Is there something I should be looking out for when purchasing a new blade to avoid this happening?
I assumed a 10" blade was a 10" blade.
General wood working tips, tricks and ideas. Anything that doesn't belong elsewhere can be discussed here.
1 post • Page 1 of 1
Who is online
Users browsing this forum: No registered users and 3 guests