How much support?

General wood working tips, tricks and ideas. Anything that doesn't belong elsewhere can be discussed here.
Bobtuck
New Member
Posts: 1
Joined: Mon Jan 14, 2019 2:55 pm
Contact:

How much support?

Postby Bobtuck » Mon Jan 14, 2019 3:14 pm

Hi all, first post be gentle :)

I'm going to install an oversize computer bench/desk that's 3 metres wide by 800mm deep....I know, I have a lot of stuff :(

It will be 25mm chipboard (nice stuff, if chipboard can be 'nice', seems quite high density)

It will be supported along the back with a batten (on the wall) and at the front I reckon I can get away with insetting the TWO legs (can't have more) by around 200mm.....that still gives me an apron or span of 2.6 metres.

Do the experienced patrons here think a 2.6M piece of 50mmx50mmx3mm steel box section would suffice and not sag (no real weight per se)?

(I can hide this behind a wood 'false apron')

My woodworking skills aren't exactly stellar....but I can get by pretty reasonably.

Many thanks for any advice.

Bob

Return to “Woodworking”

Who is online

Users browsing this forum: No registered users and 2 guests