Just bought this second hand tenon saw, (new to woodworking) and I've noticed a bend, not in the length of the saw plate but off angle from the spine itself.
Just wondering if this is normal?
Any help would be appreciated thankyou.
Tried to upload a pic but the file is too large.
U but not as extreme
Discuss hand tools here, its quieter and less dusty than the other sections.
3 posts • Page 1 of 1
- Posts: 3445
- Joined: Wed Oct 17, 2007 8:50 am
- Location: Surrey / Hampshire
welcome to the forum. you need to make a couple of posts before you can post a picture, but from your description it is probably fine. As long as the plate is flat and straight and the spine is straight it doesn't really matter about the angle of the spine to the plate.
Who is online
Users browsing this forum: No registered users and 2 guests