Page 1 of 1

New tenon saw

Posted: Wed Mar 06, 2019 1:02 pm
by Jamiethedyas
Just bought this second hand tenon saw, (new to woodworking) and I've noticed a bend, not in the length of the saw plate but off angle from the spine itself.
Just wondering if this is normal?

Any help would be appreciated thankyou.

Tried to upload a pic but the file is too large.

Like this

/
/
U but not as extreme

Re: New tenon saw

Posted: Wed Mar 06, 2019 5:10 pm
by promhandicam
welcome to the forum. you need to make a couple of posts before you can post a picture, but from your description it is probably fine. As long as the plate is flat and straight and the spine is straight it doesn't really matter about the angle of the spine to the plate.

Re: New tenon saw

Posted: Wed Mar 06, 2019 5:17 pm
by Jamiethedyas
Thankyou for the quick response, good to know! Was worried for a while there :)