I wonder if anyone can offer any information/advice about this saw?
I purchased it on ebay a year ago and it has been great for ripping down joists etc. I would now like to start using it for accurate work. To this end I have tried to align the blade so that it's parallel with the slots in the cast iron table so I can knock up a sled and increase the saw's versatility.
Looking on YouTube the (mostly American) instructions on how to do this are to loosen the cast iron bed from the cabinet and tap it into alignment. Unfortunately this won't work with my saw as the saw mechanism and motor assembly are all attached directly to the the underside of the cast top. Does anyone out there have any experience of this kind of set up? Any advice would be greatly appreciated!
If its got a cable, this is the place to talk about it.
1 post • Page 1 of 1
Who is online
Users browsing this forum: No registered users and 1 guest