Ash kitchen Ialand Top - joining planks

General wood working tips, tricks and ideas. Anything that doesn't belong elsewhere can be discussed here.
Post Reply
James Rolfe
New Member
Posts: 1
Joined: Fri Apr 21, 2023 8:26 pm
Contact:

Ash kitchen Ialand Top - joining planks

Post by James Rolfe »

Hi, I'm a newbie to this forum as I'm looking for some advice from some of the more experienced folks on here!

I've been working with timber for many years but haven't built an island top as big as this before. I'm joining four pieces of Ash together. They are all 9'4" long and the following widths: 22", 12", 12" and 18". All are approx 1.5" thick and i'm joining them together using tongue (0.25" ply) and groove with 2 part epoxy, sash clamped whilst cure takes place.

I know the joints will be strong as hell but because its so big and needs carrying about a bit to its resting place, i'm wondering if I need to also use worktop connecting bolts (routered into underneath) and also considered 3 large ones made with threaded bar to run full width.

I don't want to make work for myself and do this unnecessarily so any thoughts/advice are appreciated. Finished size 9'4" x 5'4" x 1.5" thick.

Thanks in advance!

James
Meccarroll
Subscriber
Posts: 1220
Joined: Wed Nov 27, 2013 6:37 am
Contact:

Re: Ash kitchen Ialand Top - joining planks

Post by Meccarroll »

Worktop clamps are intended for pulling together worktops in situ. I would probably use some 45x95 framed around the worktop in two places about 1200mm apart with a long 45x95 section as a carry handle so two people can carry the top. No worktop clamps for me!
Post Reply