Luna W57 Combination

If its got a cable, this is the place to talk about it.
Post Reply
clebber
New Member
Posts: 1
Joined: Wed Mar 11, 2015 10:28 am
Contact:

Luna W57 Combination

Post by clebber » Thu Mar 12, 2015 9:34 am

I have purchased one of the aboe machines. Could any of you help me get up to speed with the morticer and spindal moulder not sure how to use them

simon harper
New Member
Posts: 2
Joined: Sun Apr 18, 2021 6:03 pm
Contact:

Re: Luna W57 Combination

Post by simon harper » Sun Apr 18, 2021 6:09 pm

hi there .
Just come across your post.
Ive had one of these machines for about 20 years
I have pdf's of the manual if you need them
I wonder if you could do me a small favour. Im rebuilding the thicknesser(never used it ) and the small drive belt that runs the reduction feed box for the thicknesser (inbetween the table saw and thicknesser) is missing . Would you be able to tell me if it is a vee belt or an 'o' belt .Some rough in situ measurements of the cross section would be greatly appreciated
Regards
Simon

promhandicam
Moderator
Posts: 3516
Joined: Wed Oct 17, 2007 8:50 am
Location: Surrey / Hampshire
Contact:

Re: Luna W57 Combination

Post by promhandicam » Fri May 07, 2021 11:28 pm

welcome Simon. You do realise that this thread is 6 years old and the OP only posted once!

simon harper
New Member
Posts: 2
Joined: Sun Apr 18, 2021 6:03 pm
Contact:

Re: Luna W57 Combination

Post by simon harper » Sat Jun 05, 2021 9:49 pm

Yes .Ever the optimist

Post Reply