Sft start for 240v pillar drill

If its got a cable, this is the place to talk about it.
Post Reply
Paxman
New Member
Posts: 1
Joined: Sat Jan 23, 2021 6:37 pm
Contact:

Sft start for 240v pillar drill

Post by Paxman » Sat Jan 23, 2021 6:45 pm

Hi does anyone know where i can get a soft start for my old pillar drill.

Spec is attached. It seems to only require 4 amps but on start it can trip the 16 amp circuit.

I replaced the old switch for an NVR type but it did not solve the problem.

I have found a few diy circuits but would prefer to buy one.

Regards
Neil
Attachments
pillar drill motor.JPG

Post Reply